Niveaumat is a complete water replenishment unit. It has been designed to replenish evaporated aquarium water from a storage tank.
In all aquariums the evaporated water has to be replenished regularly. Especially in saltwater aquariums it is important to automate the replenishment of water to avoid oscillations in the salt concentration.
The SP 3000 is a peristaltic pump connected to a level sensor. The liquid is repeatedly transported by the pump hose. It can be used anywhere small amounts of liquid need to be pumped .
The metering pump is supplied with a durable synchronous motor and the pump hose is made of Santoprene®, a material specifically developed to be resistant to many chemicals and to have a very long life, typically in excess of 3 million compressions.
The synchronous motor works at a fixed speed and cannot be regulated.
Technical data
Safety voltage for the pump 230 V / 50 Hz 12 V ~
Power consumption: 4.5 watts
Maximum flow: 3 litres/hour – 50 ml/min - 0.8 ph
Connections: Tube 6/4 mm (¼”)
Motor: Synchronous
Speed: 20rpm
Engine life: >10,000 hours
Pump tube life: >3 million turns
Continuous flow: Yes
Facility
The pump can only run dry, it has not been designed for continuous use.
submerged. It must be mounted on the wall, using the rear holes, in a dry place.
The pump is self-priming and should be mounted above the water level of the
liquid stored in the tank
The outlet should always be placed above the aquarium or sump. If the pump
for with the shaft in the horizontal position then the pump will not act as a valve
anti-return The air gap between the outlet hose and the maximum water level prevents
that the aquarium water is siphoned back into the storage tank
A non-return valve must be placed in the outlet hose of the pump. prevents the
emptying of the pressure tube and ensures that the same volume is dispensed during each cycle
of operations.

Exploded view
1. Fresh water reserve
2. Level up
3. Plug
4. Check valve
5. Kalkwasser shaker
6. Engine
7. Aquarium or filter sump
8. Level sensor