The controller with digital temperature monitor T Controller Twin , is the perfect solution for the control and monitoring of heating systems and cooling units at the same time installed in an aquarium.
The T Controller Twin temperature controller is used to control both heating and cooling system units, even if the aquarium has both installed at the same time, it can control only one or both simultaneously.
T Controller Twin has a rechargeable battery that makes it store current for a long period of time, so the programmed data will not be lost in the event of a power failure. After starting up the equipment, it takes about 24 hours until the battery is fully charged and the data is stored and saved.
It is so efficient that it has a detection and measurement system with an accuracy of 0.1 ° C. The control range varies from 0 to 50 ° C, and the value is set to 1 ° C in steps.
The maximum load for the heating and cooling system of the units is 1,200 Watts. Due to the integrated double socket it is possible to connect a heating and a cooling system simultaneously.
T Controller Twin is equipped with a water corrosion proof temperature probe.
The LCD screen provides instant information on the temperature at all times. The minimum and maximum values can be set simply and easily.
How to use
When you press an arrow key, the display light will turn on. To adjust the nominal values, press the "SET" key. If the label “LOC” appears, the display needs to be unlocked. The keys can be unlocked by pressing the “SET” button and the down arrow key simultaneously until the temperature is displayed.
The temperature display starts flashing and the nominal value can be adjusted using the arrow keys. After pressing the SET key once more, the display changes to the fine check display (OK lights up).
Use the arrow keys to set the desired value, usually 1°C. By pressing the SET key again, the unit jumps back to the alarm value screen. When the set point plus the set alarm value is exceeded, a beep sounds. This value is also adjusted with the arrow keys. If you hold down the "SET" key for a while, you come to the time setting menu. The numbers are chosen by pressing "SET" and changing with the arrow keys.
No outlet can be controlled by the timer. It's just a screen. Now the drive is ready for use. Pressing "OK" enters the display mode.
As soon as the set value falls below the selected value of control accuracy, the unit activates outlet No. 2 and switches the consumer (heating). When the set temperature is exceeded, the unit activates socket No. 1 and the other consumer (cooling) is connected.
Example: The nominal value is set to 25°C, the cooling and heating control accuracy to 1°C. As soon as the temperature reaches 26°C (set value + control accuracy) the cooling unit starts. As soon as the temperature falls below the nominal value (here 25°C) the cooling unit will stop.
If the temperature drops to 24°C (setpoint - control accuracy) the heating unit starts. As soon as the temperature rises higher than the nominal value (here 25°C) the heating unit will stop.
A deactivation of at least 3 minutes prevents the heater and cooler from working against each other.
T controller twin contains a batteryrechargeable so the programmed data will not be
will be lost in the event of a power failure. After starting the computer, it takes
about 24 hours until the battery is charged and the data is stored.
For safety reasons, you should check the nominal values, especially after a power outage.
Technical data
Display: 0.1°C
Measurement range: 0 to 50°C
Resolution: 0.1°C
Contact load capacity: 1,200 Watt at 230 V AC
Air humidity: below 80%
Control range: 16 – 40°C
Setting accuracy: +/- 1°C
Necessary current: 230 V/50 Hz
Humidity: < 85%
